KEVLAR BALLISTIC SERIES 90g HYBRID / UTILITY MODEL#KG90-HUT
Elastically Tailored Composites
PURE KINETIC ENERGY
Wound for an explosive transfer of kinetic energy….however you drive it, KINETIXX® IMRT will optimize down range distance and target performance.
An active shaft that increases in frequency the greater the force applied.
This hard kicking, elastically tailored composite is engineered to improve club forgiveness and generate outrageous ball speed and precise shot control!
Filament wound Vacuum Cured Construction technology produces round, concentric and spineless golf shafts for incomparable stability, dynamic response and feedback.
Fitting the widest array of players and swing types. Each shaft profile and flex present a visible, pre-loaded fiber architecture.Tension tailored for torsional recovery and attenuation of vibration, for the purest kinetic energy transfer from shaft to clubhead.PADERSON® KINETIXX® loaded kevlar BALLISTIC series features the worlds only continuous fiber filament wound kevlar construction technology.Optimizing the extraordinary material properties producing shafts with an incredibly high tensile strength-to-weight ratio, 5x stronger than steel, with 20x the elastic strength.
KG90-HUT is a Mid-High Balance, heavier weighted Low Kick advanced composite hybrid specific shaft that delivers balanced strength from butt to tip, producing a medium-high Ballistic shot trajectory with exceptional feel.
Installation Guidelines PADERSON KINETIXXLOADED Shafts:
Installation should only be completed by a qualified, trained club builder.
All PADERSON KINETIXx loaded shafts are to be BUTT Cut to length.
Do not TIP trim any shaft model! Regardless of CPM, or club assembly config.
Tip preparation: light belt abrasion or hand sanding recommended prior to final assembly.
*To ensure a smooth and clean build, we perform a post-production tip preparation: 1″ Metalwoods, 1.25″ Irons. depending on hosel bore depth, there will in many assemblies be the need to lightly sand beyond the prepared surface delivered. Light belt abrasion is also recommended to insure a full shaft insert and adequate epoxy adhesion. Do not Chamfer tip section or blade prep (scratch) tip to prepare for epoxy.