KEVLAR LAUNCH SERIES FAIRWAY MODEL#KG65-F
Elastically Tailored Composites
PURE KINETIC ENERGY
Filament Wound, Table Rolled and Vacuum Cured, for an explosive transfer of kinetic energy….however you drive it, KINETIXX® IMRT will optimize down range distance and target performance.
An active shaft that increases in frequency the greater the force applied.
This hard kicking, elastically tailored composite is engineered to improve club forgiveness and generate outrageous ball speed and precise shot control!
Featuring our patented Filament wound and table rolled construction technology combined by vacuum curing to produce a pre-loaded stiff concentric butt to middle quadrant, with an active Table rolled middle quadrant to tip for incomparable stability, dynamic response and feedback.
A highly advanced composite that couples an extraordinary high distribution of mass with a preordained elastic response engineered to optimize swing efficiency and impact mechanics, to benefit launch trajectory and shot performance.
Designed for late hitters, smooth tempo swings, Players in search of higher trajectory, those working to produce a draw shot bias.
Plays lighter than its static weight due to the demonstrably high balance point, this will contribute to lower built club swing weight.
KG65-F is a multi-material, multi-structure advanced composite shaft that delivers a pre-loaded visible fiber structural grid engineered according to each flex, from butt to middle quadrant, producing a High-Balance Point with Low-Kick point profile, for high launch cloud piercing trajectory, with exceptional stability, feel and control.
Installation Guidelines PADERSON KINETIXX LOADED shafts:
Installation should only be completed by a qualified, trained club builder.
- All PADERSON KINETIXx loaded shafts are to be BUTT Cut to length only.
- Do not TIP trim any shaft model! Regardless of CPM, or club assembly config.
- Please do not Chamfer the tips however light belt abrasion is recommended.
*Tip preparation: light belt abrasion or hand sanding recommended prior to final assembly.
*To ensure a smooth and clean build, we perform a post-production tip preparation: 1″ Metalwoods, 1.25″ Irons. depending on hosel bore depth, there will in many assemblies be the need to lightly sand beyond the prepared surface delivered. Light belt abrasion is also recommended to insure a full shaft insert and adequate epoxy adhesion. Do not Chamfer tip section or blade prep (scratch) tip to prepare for epoxy.